|
Gunsmithing & How To Pro, Amateur & WECSOG and Tutorials, Guides & OLL Build Instructions |
|
Thread Tools | Display Modes |
#1
|
|||
|
|||
1911 sight work / dovetail cuts.
Any good places to send in a slide to have dovetails cut into the slide?
The prior owner of my 1911 did a garage job on the gun and didn't do such a great job. I'd prefer to send the gun to someone to have it fixed and done correctly. |
#3
|
|||
|
|||
1911 sight work / dovetail cuts.
Quote:
It can be fixed if properly cut. Right now it's not deep enough and the sights installed stick out on the sides. If the cut was deeper the sights would fit correctly. Last edited by DysfunctionalVet; 05-27-2016 at 9:54 AM.. |
#5
|
|||
|
|||
Ok. Since the gun isn't a match grade gun would the cost of the Novak work be worth it along with their huge backlog??
Last edited by DysfunctionalVet; 05-27-2016 at 10:00 AM.. |
#6
|
|||
|
|||
1911 sight work / dovetail cuts.
OP, I'm located in Upland, I do great work and here's my work.
Sent from my iPhone using Tapatalk Last edited by JRJCP; 05-27-2016 at 6:04 PM.. |
Thread Tools | |
Display Modes | |
|
|