Pick and pluck foam set up ideas for hard gun case

[2Asupport]

I bought a Plano XL hardcase with 2 layer pick and pluck foam.

Was trying to figure out the best way to set up 3-4 pistols with mags. Should I try upright with the barrels pointing downward or 2 layers with the pistols laying flat?

If anyone has a decent setup, i'm open to suggestions.

Thanks

[K001]

Orientate the weapons so that when you open the case at the range the barrels will be facing down range

[2Asupport]

Originally Posted by K001

Orient the weapons so that when you open the case at the range the barrels will be facing down range

Ahhhh...that is a good point!! I'll make sure they are oriented in 1 direction.

[sonofeugene]

And decide where on the shooting bench you want to place your case and how it will be oriented. That will also determine which direction to point the guns inside.

[2Asupport]

Thanks for the advice. I think I will be setting up my pistols vertically, barrel downwards with mags on the side.

That way I won't have to remove everything from the top layer in order to access the bottom layer while at the range.