[Crysknife1013]

Originally Posted by syferstream

So crysknife can you upload the picture of just your barrel post-cerakote and post-fitting so I can get a gauge of where you dremel'd and sanded? Was it deep enough that you bit into the actual steel?

Barrel Breach View [A] by dalipiojr, on Flickr


Barrel Breach View [B] by dalipiojr, on Flickr


Barrel Breach View [C] by dalipiojr, on Flickr


Barrel Breach View [D] by dalipiojr, on Flickr


Underside of Muzzle by dalipiojr, on Flickr


Front of Hood [A] by dalipiojr, on Flickr


Front of Hood [B] by dalipiojr, on Flickr


Front of Hood [C] by dalipiojr, on Flickr


Underside of feed ramp by dalipiojr, on Flickr

Where you see bare metal is pretty much where I ground and sanded.

Where the Cerakote has been scraped off and worn down is actually just the wear and tear from shooting 50 rounds through the pistol after I refit the barrel, reassembled and took it to the range to test fire.