View Single Post
Old 11-09-2019, 12:36 PM
kendog4570's Avatar
kendog4570 kendog4570 is offline
Veteran Member
Join Date: Dec 2008
Location: Oakhurst, CA
Posts: 4,362
iTrader: 30 / 100%

Originally Posted by ar15barrels View Post
It's really a shame that the little bar code did not survive the machining.

Bar code still there in the radius cut. The last pic with the wood stock is an early PSS 24" 308 receiver for comparison. Just cut the hump out. I could have set the lugs back too.

Factory bolts pass the close test. I wanted to retain all the primary extraction inherent in this bolt/receiver combination.
Reply With Quote