View Single Post
Old 03-25-2013, 8:36 PM
dynamomark80's Avatar
dynamomark80 dynamomark80 is offline
Join Date: Sep 2012
Posts: 203
iTrader: 0 / 0%

Originally Posted by bigjon69 View Post
well you could install the barrel with some copper tubing and hammer still using headspace guages. and you can do a screw build. one person built an ak using tootk picks to hold front trunnion to the receiver it worked. all of the bolt thrust is contained in the trunnion
I would rather not just pond my barrel in. I looked into a screw build but i think I will pass on it for my first build.

Originally Posted by tvfreakarms View Post
I have all my parts kit and ready to go.
i would like to get on this as well
where did you find a parts kit? I see $200 kits made to work with a milled receiver but I dont want to spend a ton on a milled receiver.
I fear paper cuts far more than firearms.
Reply With Quote