View Single Post
  #28  
Old 11-29-2012, 6:59 PM
drg-racr drg-racr is offline
Junior Member
 
Join Date: Apr 2012
Posts: 25
iTrader: 0 / 0%
Default

Mindwreck....Sorry to hear about your detent hole offset. That will cause you problems, mine was about .025 offset and the safety was pointing off far enough that the trigger would not work properly. I just made a new thread showing how I fixed mine and I think it may be about the only way you can fix yours. I'll post the link in this thread.

Klewan....It is best to drill the trigger/hammer/safety holes before you mill the FCG pocket. A lot of lowers get drilled to size and it works just fine but I do drill a little undersize and ream the holes on mine.
Reply With Quote