Thread: Casting bullets
View Single Post
  #26  
Old 04-19-2013, 10:04 PM
Solus's Avatar
Solus Solus is offline
Senior Member
 
Join Date: Dec 2011
Location: San Bernardino
Posts: 548
iTrader: 22 / 100%
Default

you arent waiting for the lead to cool off enough. When casting make sure the lead solidifies before moving the sprue plate. Also make sure it is on tight. Swirls are bad. They are called wrinkles and it means its too cold. Frosting is too hot. But its better to be frosty rather than wrinkly. Good luck FYI stick on wheel weights are pure lead.
__________________
On the blue side
Reply With Quote