View Single Post
Old 12-02-2013, 7:10 PM
Addax's Avatar
Addax Addax is offline
Join Date: Apr 2006
Posts: 4,075
iTrader: 65 / 100%

Hello Everyone,

Thank you for being patient.

We have uploaded the Addax-CGF Upper Receiver part onto our website.

Link: Addax-CGF Mil-Spec AR15 Upper Receiver

Due to the holiday season upon us at this point, we are asking for a 60 day lead time. At this point we feel 60 days allows us enough of a buffer factoring in the Xmas and New Years holidays, time to process orders, laser engrave and ship.

We are taking orders starting today 12/2/2012, and ending 1/4/2014.

We will process orders when we are ready to laser engrave to ensure that your order is fully processed and your upper(s) will be laser engraved prior to shipping.

The cost of $125.00 includes one CGF logo laser engraved in one of three locations which you can choose at check out. You will have to use the Customize button when ordering the product on our website. You will see a bright red button that says: CUSTOMIZE, next to the ADD TO CART button. If you do not select one of the three locations listed below, we will not know where you want the engraving to be done.

1) Inside Ejection Port Door
2) Top rear of the Receiver
3) Left Side (opposite side of ejection port side)

$10.00 will be donated to CGF for each upper sold.

Any addtional CGF logo's will cost $20.00 per instance. You can note this at check out, and we require that you contact us via email once you place your order to request for the additional CGF Logo Engraving. We will not laser engrave in any other location than what is specified above.

Sales Tax and Shipping are extra.

Please email us with any questions to

Please do not PM us with order questions, or post order questions in this thread, since these will go unanswered by our order processing staff.

Thank you for your participation and continued support of the Calguns Foundation and Addax Tactical.

Disclaimer note: We cannot always guarantee a 100% anodizing color/tone match to the CGF lower receivers since the upper receivers are being anodized at a different time and batch, but it should be very very close to an even match from what we have seen so far from our current production runs.

Thank you,
1431 Truman St.
Unit E
San Fernando, CA 91340


Phone: (818) 361-5008

Last edited by Addax; 12-02-2013 at 7:57 PM..
Reply With Quote